Arduino MATERIA 101 Manuel d'utilisateur télécharger pdf (Page 37)

Assembly Manual

Arduino Materia 101

assEmBlINg ThE fRamE

Fig. 22

Fig. 24

Fig. 23

Fig. 25

Fig. 23

Take the end stop three wire cables

(2) (dedicated to the Z end-stop), cut

off the tinned ends and remove about

10mm of the cover. Place onto every

wire a 5mm piece of the 3mm shrink.

Couple the wires by intertwining the

same colour ends (red, black, blue)

so you can obtain a 1.5m cable with

connectors placed at each end.

Fig. 24 - 25 - 26

Connect the soldered end stop three

wire cables to the Z end-stop. Take

care to respect the polarity: RED=VCC;

BLACK =GND; BLUE=SIG (fig.24).

Connect the two remaining grey

cable connectors to the Y end-stop,

the white-brown-green with polarity

WHITE=VCC; BROWN = GND; GREEN

= SIG. The remaining connector to X

end-stop with polarity: YELLOW=VCC;

GREY=GND; PINK=SIG.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 54 55

Pas de commentaire

Arduino MATERIA 101 Manuel d'utilisateur Page 37