Arduino MATERIA 101 Manuel d'utilisateur télécharger pdf (Page 33)

Assembly Manual

Arduino Materia 101

assEmBlINg ThE fRamE

Fig. 6

Now set the pulleys, as pictured,

and tighten the pulley’s grub screws

(you will tighten them more during

calibration). You need the bars to stay

in their site without moving.

Fig. 7 - 8

Tighten at least 1 cm of the Z axis

end-stop knob. You have to use just

a bit of threadlocker on all of the

screw’s length.

Fig. 9

Take the LCD display, M3x10 nylon

stand-offs (4) and M3 nuts (4).

Fasten the stand-offs onto the

external display’s four holes then to

the LCD side (see the picture) using

the M3 nuts (4).

Fig. 6

Fig. 9

Fig. 7

Fig. 10

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 54 55

Pas de commentaire

Arduino MATERIA 101 Manuel d'utilisateur Page 33