Arduino MATERIA 101 Manuel d'utilisateur télécharger pdf (Page 21)

21 User Manual

Arduino Materia 101

PUTTING IN TENSION THE

EXTRUDER’S RUBBER BANDS

Your Arduino Materia 101 is equipped with

a cushioned versus pulley sprocket wire

drag. This solution allows to compensate for

thickness variations that some filaments can

have, allowing you to bring the press anyway.

The correct tension of the compensating

Springs allows optimum filament drive

Select the display “Prepare” menu the option

“Change filament”. Wait until the machine

ejector cycle terms and once finished, insert

the wire. While loading try to lock the thread

with your fingers; If this were to lead to a

“slip” of the sprocket on the filament, tighten

the springs until you have an outlet to blow

away the engine (you should hear a ping like

a tak tak).

Similarly, the springs must not be too

narrow to protect the motor is too under

stress and consequently lose steps.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 36 37

Pas de commentaire

Arduino MATERIA 101 Manuel d'utilisateur Page 21